chuka_lis (chuka_lis) wrote,
chuka_lis
chuka_lis

Firing china

Firing china paint isn't as difficult or critical as firing clay because the clay body and glaze arent really going through major physical and chemical changes..
 It is easy is to use  the ramp fire program and set it so that the first ramp fires as quickly as possible  ( 9999 degrees/hour) and then set the end temp for whatever cone you want to fire to . ( There is also a cone chart in that same thread on the forum ...  cone  017 is about 1380 F*, 015 is about 1480 F*.... Its not super critical.)
One ramp, as fast as it will fire... The small  Paragon Home Artist kiln takes about 50 minutes, the large Olympic takes about 2 1/2    It is not critical to vent the kiln anymore ... unless you firing lusters or gold . Then  vent it till it stops smoking...   
Do make sure that the pieces aren't sitting directly on the kiln shelves. Put a stilt under them to get air flow underneath .    
When you set it to fire  at highest temperature, it still takes time.. The only thing that is happening is that the relays aren't turning on and off . The heat just goes straight up . (The relays just slow down the firing speed by turning the elements on and off ).
Tags: china, для памяти
Subscribe

  • 3 млн

    Число смертей от коронавируса САРС2 в мире перевалило за 3 млн. Coronavirus Cases: 140,547,010 Deaths: 3,012,649 Ранее самым смертоносным (по…

  • Количество реинфекций

    Ретроспективное когортное исследование в одной из госпитальных сетей показало, с точки зрения авторов, что возможные реинфекции ковидом происходят…

  • Заболели после полной вакцинации.

    СДС отчиталось, что среди полностью вакцинированных, подтвержденно ПЦР заболело 5800 человек. Из них- 396 заболели ковидом тяжело, и 74- умерли.…

  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

  • 0 comments